>  
resQ Services   >  Extended Warranty   >  resQ Installation Service
undefined
*Note: Some images are for illustration. Not all accessories shown are part of the product.
View Slideshow

Article ID: 600503177

resQ Installation Service
Print
Key Features
  • • Check feasibility of location for installation
  • • Recommendations on appropriate location
  • • Installation and demo
Finance Schemes
    No finance schemes available for this product
  • ₹1,600
  • Description
  • Specifications
Unpack the Tower AC & Allied Accessories
We will unbox all the contents of the packaging, including the Indoor & Outdoor Unit, Pipes, Power Cable and the rest.
Perform a feasibility check
  • Before we begin with the installation, we’ll check to see if the place where you want the Tower AC installed has everything needed, such as an accessible power point & adequate area on the other side of the wall for the Outdoor unit.
  • The service engineer might recommend you solutions if there are any concerns.
    Install the Tower AC
  • We will install the outdoor unit & pull in pipes through the hole in the wall that has been made for this purpose.
  • We will then fix the indoor unit following which the pipes shall be connected to the indoor unit.
  • To complete installation, we will fill the hole with cement to ensure optimum AC experience.
    Connect the Power Supply
    We will then fix the power cable as per your requirement to the nearest power plug.
    Give you a demonstration
  • Before we leave, we will switch on & run the AC for at least ten minutes.
  • We’ll run you through the key features of the product and how to use it.
  • You can see if everything’s running fine and ask questions about the product related to warranty, care & maintenance & the various do’s & don’ts.

    • Specifications

    General Information
      Additional Benefits
    • ResQ will do Non standard Installation ( Superior Installation – On Chargeable Basis)
    • Indoor wire harnessing with pin clamp & casing capping.
    • PVC pipe inserting in the wall hole.
    • Wall hole filling with white cement.
    • Stands for Outdoor unit – Wall mount stand/Floor mount stand.
    • Rubber pad need to place in between unit and stand.
    • Drain pipe routing .
    • Use single power cable for electrical connection.
    • Vinyl tape wrapping on insulation sleeve.
    • Omega clamp for copper pipe .
    • Tighten the insulation end by cable tie.
    • Uˈ trap in copper pipe.
    • Sun shade for ODU.
      • Service Location
      At customer’s place
    marketing marketing marketing